With Viking, you can have professional-quality refrigeration systems in the convenience of your very own home. It makes sense that you would not intend to trust your investment to simply any type of appliance repair firm. That’s why you ought to call the Viking refrigerator repair service specialists.
We offer remarkable Viking refrigerator repair service seven days a week. Our specialists are on phone call almost everywhere near your location. When you need exceptional support for your premium refrigerator, call us.
The control device of your Viking refrigerator keeps track of the important parts of the device. If a fault is found, the electronic screen provides an error code to assist locate as well as repair the concern.
The very first step to dealing with any kind of issue is to confirm the error is legit. To confirm an error code, you will certainly need to reboot the refrigerator.
To reboot your fridge:
Disconnect the refrigerator from the wall or switch off power to the electrical outlet at the circuit breaker.
Wait 5 mins.
Return power to the fridge.
If the mistake code returns, it is a genuine error. Refer to the following chart for more troubleshooting assistance.
Mistake Code Detection
The microprocessor in the control consistently checks critical refrigeration system elements for appropriate procedure. If element specifications go beyond regular operating specs, an audible alarm will certainly sound 6 (6) times every min and the screen will automatically blink the respective error code. If numerous errors are kept in mind with the system, the error codes will certainly be displayed sequentially.
Caution Alarm system
The Tru Protect ™ system will educate you if the unit is not working appropriately. It gives both visual as well as distinct notifies if the temperature level rises above or drops listed below the set temperature, if there is a power failure, or if the door is left ajar.
- Door Ajar: If the door is exposed for greater than 5 (5) minutes, an audible alarm system will sound three (3) times every 30 secs and also the LED light will flash eco-friendly. This will certainly stop as quickly as the door is closed.
- High and Low Temperature Level: If the unit reaches a temperature either over or below the set point temperature for more than one (1) hr, an audible alarm will certainly sound six (6) times every min and also the LED will certainly blink red. This will continue till the alarm system is reset. The alarm system may occur when changing set-points over of 10 degrees F and/or high usage which is typical.
- Power Failure: If the system experiences a power failing, the LED will blink brownish-yellow. This will proceed until the alarm is reset. With a power failure, no distinct signal is heard. The alarm may occur upon initial installment which is normal since the device was gone for the manufacturing facility to confirm quality.
Resetting the Alarm systems
Close door to reset Door Open alarm system. Press the “ON/OFF” button for about one (1) second to reset all various other distinct and show alarms.
NOTE: Although pressing the “ON/OFF” button will reset the alarms, the alarm will return to if the “alarm system condition” still exists.
Solution Diagnostics Setting
Solution Diagnostics Setting permits you to recognize the firmware as well as software application versions, test condition of “model particular” system elements and sensing units, and transform state of components where suitable (i.e.– compressor on/off, etc.).
ERROR CODE | CAUSE | SOLUTION |
Ed | Failed defrost temperature sensor | It will be necessary to locate and replace the failed part. |