With Viking, you can have professional-quality refrigeration systems in the convenience of your own home. It makes sense that you would not intend to trust your investment to just any type of home appliance repair service company. That’s why you ought to call the Viking fridge fixing specialists.
We provide exceptional Viking refrigerator repair work service seven days a week. Our specialists are on call almost everywhere near your location. When you require premium support for your premium fridge, call us.
The control unit of your Viking fridge monitors the crucial elements of the system. If a mistake is identified, the digital screen offers an error code to help situate as well as repair the problem.
The first step to solving any kind of problem is to verify the mistake is legit. To validate a mistake code, you will need to reboot the fridge.
To reboot your fridge:
Disconnect the fridge from the wall or switch off power to the outlet at the breaker.
Wait five minutes.
Return power to the fridge.
If the error code returns, it is a legitimate mistake. Describe the following graph for additional fixing aid.
Error Code Detection
The microprocessor in the control continuously checks crucial refrigeration system elements for appropriate operation. If component criteria exceed regular operating specs, an audible alarm will appear 6 (6) times every min and the display will immediately blink the respective error code. If several mistakes are kept in mind with the device, the mistake codes will certainly be displayed sequentially.
Warning Alarm
The Tru Protect ™ system will notify you if the device is not working appropriately. It provides both visual and also distinct signals if the temperature level rises above or falls below the established temperature level, if there is a power failure, or if the door is left open.
- Door Ajar: If the door is left open for greater than 5 (5) minutes, a distinct alarm system will certainly appear 3 (3) times every 30 secs and also the LED light will certainly blink green. This will certainly stop as soon as the door is closed.
- Low And High Temperature: If the device gets to a temperature level either over or below the set factor temperature for greater than one (1) hr, a distinct alarm will seem six (6) times every minute as well as the LED will flash red. This will proceed until the alarm is reset. The alarm system may take place when transforming set-points in excess of 10 degrees F and/or high use which is typical.
- Power Failing: If the unit experiences a power failing, the LED will certainly flash brownish-yellow. This will continue up until the alarm is reset. With a power failure, no distinct signal is listened to. The alarm system may occur upon initial installation which is typical because the device was performed at the factory to confirm top quality.
Resetting the Alarms
Close door to reset Door Ajar alarm. Press the “ON/OFF” switch for approximately one (1) 2nd to reset all various other audible as well as display alarm systems.
NOTE: Although pushing the “ON/OFF” button will certainly reset the alarm systems, the alarm will return to if the “alarm condition” still exists.
Solution Diagnostics Setting
Solution Diagnostics Mode allows you to determine the firmware and also software application versions, examination standing of “design details” system elements as well as sensing units, and alter state of parts where appropriate (i.e.– compressor on/off, etc.).
ERROR CODE | CAUSE | SOLUTION |
E4 | A fault with the display thermistor has been detected. | This error may be caused by disconnected wiring, shorted wires, or a faulty thermistor. It is necessary to test all connections and the affected parts to repair the issue. |