With Viking, you can have professional-quality refrigeration systems in the convenience of your very own home. It makes good sense that you wouldn’t want to trust your investment to simply any home appliance repair business. That’s why you must call the Viking fridge fixing specialists.
We provide remarkable Viking fridge fixing service 7 days a week. Our service technicians get on phone call all over near your area. When you require exceptional assistance for your premium fridge, call us.
The control device of your Viking fridge keeps track of the vital parts of the device. If a mistake is detected, the digital display provides a mistake code to aid locate and also fix the concern.
The very first step to fixing any problem is to verify the mistake is legitimate. To confirm a mistake code, you will certainly need to reboot the fridge.
To reboot your refrigerator:
Unplug the fridge from the wall surface or shut off power to the electrical outlet at the circuit breaker.
Wait five mins.
Return power to the refrigerator.
If the error code returns, it is a reputable mistake. Refer to the complying with graph for further troubleshooting help.
Mistake Code Discovery
The microprocessor in the control consistently keeps track of important refrigeration system parts for appropriate operation. If part criteria exceed typical operating requirements, an audible alarm will certainly appear 6 (6) times every min and also the screen will immediately flash the respective error code. If several mistakes are noted with the system, the mistake codes will certainly be shown sequentially.
Warning Alarm system
The Tru Protect ™ system will certainly inform you if the device is not functioning properly. It supplies both visual and audible signals if the temperature level rises above or falls below the set temperature, if there is a power failure, or if the door is left ajar.
- Door Ajar: If the door is left open for greater than 5 (5) mins, an audible alarm will seem three (3) times every 30 seconds as well as the LED light will certainly flash eco-friendly. This will certainly stop as soon as the door is shut.
- High and Low Temperature Level: If the device gets to a temperature level either over or below the set point temperature level for more than one (1) hr, a distinct alarm system will certainly seem six (6) times every min as well as the LED will certainly flash red. This will certainly proceed till the alarm system is reset. The alarm may happen when altering set-points in excess of 10 degrees F and/or high usage which is normal.
- Power Failure: If the device experiences a power failing, the LED will certainly flash amber. This will proceed up until the alarm is reset. With a power failing, no audible signal is listened to. The alarm might take place upon preliminary installment which is normal considering that the system was run at the factory to confirm quality.
Resetting the Alarm systems
Close door to reset Door Ajar alarm system. Press the “ON/OFF” button for roughly one (1) 2nd to reset all various other audible as well as show alarms.
KEEP IN MIND: Although pushing the “ON/OFF” switch will reset the alarm systems, the alarm will certainly return to if the “alarm system problem” still exists.
Service Diagnostics Mode
Service Diagnostics Setting permits you to recognize the firmware and also software versions, test status of “version certain” system elements and sensors, and change state of parts where suitable (i.e.– compressor on/off, etc.).
ERROR CODE | CAUSE | SOLUTION |
CL | Condenser Coils need maintenance. | To keep your refrigerator running at optimal performance, it is necessary to periodically clean the condenser coils. In our refrigerator maintenance guide, we recommen cleaning your refrigerator’s condenser coils every six monh |