Software Model Number
Model | Description | Software Model Number |
DFUW, DUWC, VUWC | 24 inch Wine Cellar | 11 |
DFUR, DUAR, VUAR | 24 inch Beverage Center | 21 |
DFRD, DURD, VURD | 24 inch Refrigerated Drawers | 16 |
Viking Fridge Diagnostic Information
Service Diagnostics Setting allows you to determine the firmware and also software variations, test condition of “design certain” system parts and sensing units, and also transform state of components where appropriate (i.e.– compressor on/off, etc.).
Enabling Solution Mode: To enable Service Setting, press and hold the “WARMER” button while pushing the “COLDER” switch four times within 5 seconds.
- You can not enable Service Mode while in Establish Mode. – All system functions will certainly remain in their existing state while in Service Mode.
- Alarm systems are handicapped during Solution Mode and reset after exiting Solution Mode.
- Solution Mode will automatically disable after five (5) minutes of no keypad entrance
After going into Service Mode, the very first number that you will certainly see suggests the software program version number for the particular device you are servicing. For instance, if you are servicing a 24 inch wine cellar (DFUW, DUWC, VUWC), the initial number you will see is 11. See chart listed below for matching design and software program reference.
The 2nd number you will certainly see indicates the software application variation launch. As an example, if you see 44 on the display panel it shows software variation 4.4.
Diagnostics:
While in Service Mode, press the “COLLECTION” switch to tip with Tests 0-9. The initial number of the display will show the test number. The 2nd figure suggests the current state of each component under examination and also is shown as “1” being ON, CLOSED, or SHORTED and also “0” being OFF or OPEN. Examinations 0 and 1 disclose an open or shorted problem detected at the sensing unit inputs. Examinations 2 through 6 enable you to transform lots ON with the “WARMER” button and also OFF with the “COLDER” button. Examinations 7 via 9 validate state adjustment of the door switches and/or magnetic reed sensor. The part tests readily available are explained in Available Component Tests chart.
SOUND | POSSIBLE CAUSE | SOLUTION |
Thumping | Ice cubes from ice maker drop into ice bucket. | Normal operation |