Software Model Number
Model | Description | Software Model Number |
DFUW, DUWC, VUWC | 24 inch Wine Cellar | 11 |
DFUR, DUAR, VUAR | 24 inch Beverage Center | 21 |
DFRD, DURD, VURD | 24 inch Refrigerated Drawers | 16 |
Viking Refrigerator Diagnostic Info
Service Diagnostics Mode enables you to determine the firmware and software versions, test condition of “version details” system components and also sensing units, and transform state of parts where relevant (i.e.– compressor on/off, and so on.).
Enabling Service Setting: To allow Solution Setting, press and hold the “WARMER” button while pushing the “COLDER” switch four times within five seconds.
- You can not make it possible for Solution Mode while in Set Setting. – All system features will remain in their current state while in Service Setting.
- Alarms are handicapped throughout Solution Setting and also reset after leaving Service Mode.
- Solution Mode will automatically disable after 5 (5) minutes of no keypad entrance
After going into Solution Setting, the initial number that you will see shows the software application version number for the particular system you are servicing. For instance, if you are servicing a 24 inch wine rack (DFUW, DUWC, VUWC), the first number you will certainly see is 11. See graph below for matching version and also software application recommendation.
The second number you will see shows the software application variation launch. For instance, if you see 44 on the screen panel it indicates software program version 4.4.
Diagnostics:
While in Service Setting, press the “COLLECTION” switch to tip via Examinations 0-9. The initial number of the display will certainly show the test number. The second figure suggests the existing state of each element under test and is displayed as “1” being ON, CLOSED, or SHORTED and “0” being OFF or OPEN. Tests 0 and also 1 disclose an open or shorted problem discovered at the sensing unit inputs. Examinations 2 through 6 enable you to turn lots ON with the “WARMER” button and also OFF with the “COLDER” switch. Tests 7 via 9 verify state modification of the door changes and/or magnetic reed sensor. The element examinations available are described in Offered Part Tests graph.
PROBLEM | POSSIBLE CAUSE | WHAT TO DO |
Water droplets form outside of door | Check gaskets for proper seal | Clean it |
Humidity levels are high | Hot, humid weather can increase condensation. | |
Controls require adjustment | Adjust controls |