Software Model Number
Model | Description | Software Model Number |
DFUW, DUWC, VUWC | 24 inch Wine Cellar | 11 |
DFUR, DUAR, VUAR | 24 inch Beverage Center | 21 |
DFRD, DURD, VURD | 24 inch Refrigerated Drawers | 16 |
Viking Refrigerator Diagnostic Details
Service Diagnostics Setting permits you to recognize the firmware as well as software variations, examination status of “version certain” system components as well as sensing units, and transform state of components where applicable (i.e.– compressor on/off, etc.).
Enabling Solution Mode: To enable Solution Mode, press and also hold the “WARMER” switch while pressing the “COLDER” switch 4 times within five secs.
- You can not make it possible for Service Setting while in Establish Mode. – All system features will remain in their current state while in Service Mode.
- Alarm systems are handicapped throughout Service Setting as well as reset after exiting Solution Setting.
- Service Setting will immediately disable after five (5) minutes of no keypad entry
After entering Solution Mode, the initial number that you will certainly see indicates the software application version number for the particular device you are servicing. For example, if you are servicing a 24 inch wine cellar (DFUW, DUWC, VUWC), the initial number you will certainly see is 11. See graph listed below for matching design as well as software referral.
The second number you will certainly see indicates the software program version launch. For instance, if you see 44 on the display screen panel it shows software program version 4.4.
Diagnostics:
While in Service Mode, press the “SET” button to step through Tests 0-9. The very first digit of the display will certainly reveal the examination number. The second digit shows the existing state of each element under test and is shown as “1” being ON, CLOSED, or SHORTED and also “0” being OFF or OPEN. Examinations 0 and 1 disclose an open or shorted condition found at the sensing unit inputs. Tests 2 with 6 enable you to transform loads ON with the “WARMER” switch as well as OFF with the “COLDER” button. Tests 7 through 9 confirm state change of the door switches and/or magnetic reed sensor. The part tests available are defined in Offered Part Examinations graph.
PROBLEM | POSSIBLE CAUSE | WHAT TO DO |
Refrigerator has an odor | Compartment is dirty or has odor causing food. | Clean it |