Software Model Number
Model | Description | Software Model Number |
DFUW, DUWC, VUWC | 24 inch Wine Cellar | 11 |
DFUR, DUAR, VUAR | 24 inch Beverage Center | 21 |
DFRD, DURD, VURD | 24 inch Refrigerated Drawers | 16 |
Viking Fridge Diagnostic Info
Service Diagnostics Mode permits you to identify the firmware and also software versions, examination standing of “design details” system parts and sensing units, as well as alter state of parts where relevant (i.e.– compressor on/off, etc.).
Enabling Solution Setting: To make it possible for Service Mode, press as well as hold the “WARMER” button while pressing the “COLDER” button 4 times within 5 secs.
- You can not make it possible for Service Setting while in Establish Setting. – All system features will continue to be in their existing state while in Service Mode.
- Alarm systems are handicapped throughout Service Mode and reset after exiting Solution Setting.
- Service Setting will immediately disable after five (5) mins of no keypad access
After going into Solution Mode, the first number that you will certainly see indicates the software program version number for the particular device you are servicing. As an example, if you are servicing a 24 inch wine rack (DFUW, DUWC, VUWC), the initial number you will certainly see is 11. See graph below for matching design and software program referral.
The second number you will see indicates the software program variation release. For instance, if you see 44 on the screen panel it indicates software version 4.4.
Diagnostics:
While in Service Setting, press the “SET” button to tip through Tests 0-9. The initial figure of the display will certainly reveal the examination number. The 2nd number suggests the current state of each part under examination and also is shown as “1” getting on, CLOSED, or SHORTED and “0” being OFF or OPEN. Examinations 0 as well as 1 disclose an open or shorted problem detected at the sensor inputs. Examinations 2 with 6 enable you to transform tons ON with the “WARMER” button as well as OFF with the “COLDER” switch. Examinations 7 with 9 confirm state adjustment of the door switches and/or magnetic reed sensor. The part examinations readily available are described in Readily available Part Examinations graph.
PROBLEM | POSSIBLE CAUSE | WHAT TO DO |
Food temperature is too cold | Condenser coils are dirty | Clean coils |
Refrigerator or freezer controls are set too high. | Properly adjust controls | |
Food temperature is too warm | Door is not closing properly | Check for internal obstructions that are keeping door from closing properly. Refrigerator is not level. See installation instructions for details on how to level your refrigerator. Check gaskets for proper seal, clean if necessary |
Condenser coil is dirty. | Clean coils | |
Rear air grille is blocked. | Check the positioning of food items in refrigerator to make sure grille is not blocked. Rear air grilles are located under produce drawers. | |
Doors have been opened frequently or has been opened for long periods of time | Reduce time door is open Organize food items efficiently to assure door is open for shortest time |